d&b V-Series - Manual (Page 26)

3. Add further cabinets
1. Prepare the Front links of the next cabinet as described in
section Þ Chapter 2.11. " Cabinet rigging mechanism" on
page 19.
2. Lift the current assembly to a suitable working height.
3. Position the next cabinet below the assembly.
4. Lower the assembly onto the cabinet until the Front links of the
bottom cabinet fit into the slots of the upper cabinet.
5. Insert the second Locking pins of the cabinet's Front links on
both sides.
6. On the rear rigging strand, release the Locking pins of both
cabinets.
7. Fold out the Rear link of the upper cabinet.
8. Reinsert the Locking pin on the upper cabinet.
9. Fold the Rear link into the rigging strand of the bottom cabinet.
10. Reinsert the two Locking pins on the bottom cabinet.
To add further cabinets, proceed in the same manner until the
assembly is completed.
Splay option
The Front links of the SUB cabinets allow for a splay angle of 2.5°
between adjacent SUB cabinets. Before hoisting the array, the
angle can be set in two ways:
free The second Locking pin of the cabinet's Front link is
inserted in the top hole of the front rigging strand as
shown in the graphic opposite. This can be done for
all cabinets in one step.
The angle opens itself as soon as the array is
hoisted.
blocked The second Locking pin of each cabinet's Front link
is inserted in the second hole cabinet by cabinet
during hoisting as shown in the graphic opposite.
Due to the design of the Front link mechanism, the
Locking pin can be inserted free of load.
SUB to SUB, 2.5° splay, free
SUB to SUB, 2.5° splay, blocked
d&b V-Series Rigging manual (1.9 EN) 26