d&b V-Series - Manual (Page 15)

2.7.3. Dual pickpoint operation
With "Dual pickpoint operation" the vertical aiming of the array is
set by trimming the hoist motors after the array has been fully
assembled and lifted to its operating position.
The corresponding hole positions are calculated using ArrayCalc.
Attachment
1. Choose the appropriate hole positions for the Front and
Rearpick on the Flying frame center bar according to the
ArrayCalc calculation and attach the Load adapters
correspondingly (Direction: Full grid 1/1 pickpoint Detent).
2. Connect the Hoist connector chains or motor hooks to the
shackles of the Load adapters.
ArrayCalc Dual pickpoint
d&b V-Series Rigging manual (1.9 EN) 15