Altera Transceiver Signal Integrity - Manual (Page 42)

6–18 Chapter 6: Board Test System
Using the Board Test System
Transceiver Signal Integrity Development Kit, February 2013 Altera Corporation
Stratix V GT Edition User Guide
GTB MMPX Tab
The GTB MMPX tab allows you to run transceiver loopback tests on each GT channel
at high data rates up to 28 Gbps. You can also view each GT channel TX output via an
oscilloscope for eye diagram analysis and measurements.
Figure 6–9 shows the GXB
MMPX tab.
The following sections describe the controls on the GXB MMPX tab.
Status
The Status control displays status information during the loopback test. For details on
this control, refer to
“Status” on page 6–11 .
Port
■ GTB Transceivers 0 —GT channel 0
■ GTB Transceivers 1 —GT channel 1
■ GTB Transceivers 2 —GT channel 2
Figure 6–9. The GTB MMPX Tab