Altera Transceiver Signal Integrity User Manual
Page 22
![background image](https://www.manualsdir.com/files/763783/content/doc022.png)
4–6
Chapter 4: Development Board Setup
Factory Default Switch Jumper Settings
Transceiver Signal Integrity Development Kit,
February 2013
Altera Corporation
Stratix V GT Edition User Guide
8. Set jumper blocks (J26, J28) to match
.
1
For more information about the FPGA board settings, refer to the
Table 4–8. Jumper Settings
Board Reference
Description
Shunt Position
J26
Fan select — Pins 1-2 select auto operation.
Installed
J26
Fan select — Pins 2-3 select fan on.
Not installed
J28
PGMSEL (logic 1) — Pins 1-2 select user-defined image.
Not Installed
J28
PGMSEL (logic 0) — Pins 2-3 select factory image.
Installed
This manual is related to the following products: