Altera Transceiver Signal Integrity - Manual (Page 16)

3–4 Chapter 3: Software Installation
Installing the USB-Blaster Driver
Transceiver Signal Integrity Development Kit, February 2013 Altera Corporation
Stratix V GT Edition User Guide
Installing the USB-Blaster Driver
The Stratix V GT development board includes integrated USB-Blaster circuitry for
FPGA programming. However, for the host computer and board to communicate, you
must install the USB-Blaster driver on the host computer.
f Installation instructions for the USB-Blaster driver for your operating system are
available on the Altera website. On the
Altera Programming Cable Driver Information
page of the Altera website, locate the table entry for your configuration and click the
link to access the instructions.
examples
Contains the sample design files for the Transceiver Signal Integrity Development Kit, Stratix V GT
Edition.
factory_recovery
Contains the original data programmed onto the board before shipment. Use this data to restore
the board with its original factory contents.
Table 3–1. Installed Directory Contents
Directory Name Description of Contents