Altera Transceiver Signal Integrity - Manual (Page 34)

6–10 Chapter 6: Board Test System
Using the Board Test System
Transceiver Signal Integrity Development Kit, February 2013 Altera Corporation
Stratix V GT Edition User Guide
Status
The Status control displays status information during the loopback test. For details on
this control, refer to
“Status” on page 6–11 .
Port
Use the following controls to select an interface to apply PMA settings, data type and
error control:
■ SFP+
■ XFP
PMA Setting
The PMA Setting button allows you to make changes to the PMA parameters that
affect the active transceiver interface. For details, refer to “PMA Setting” on
page 6–12 .
Data Type
The Data type control specifies the type of data contained in the transactions. For
details, refer to
“Data Type” on page 6–12 .
Error Control
This control displays data errors detected during analysis and allows you to insert
errors. For details, refer to
“Error Control” on page 6–13 .
Loopback
This control allows you control and analyze loopback performance. For details, refer
to
“Loopback” on page 6–13 .