Altera Partial Reconfiguration IP Core User Manual
Page 9
Table 3: Conduit Interface
These options are available when Enable Avalon-MM slave interface parameter is turned Off.
Port Name
Width
Direction
Function
pr_start
1
Input
A signal arriving at this port
asserted high initiates a PR
event. You must assert this signal
high for a minimum of one clock
cycle and de-assert it low prior to
the end of the PR operation so
that the PR IP core is ready to
accept the next
pr_start
trigger
event when the
freeze
signal is
low.
This signal is ignored during
JTAG debug operations.
data[]
1, 2, 4, 8, 16, or 32
Input
Selectable input PR data bus
width, either x1, x2, x4, x8, x16,
or x32.
Once a PR event is triggered, it is
synchronous with the rising edge
of the
clk
signal whenever the
data_valid
signal is high and
the
data_read
signal is high.
This signal is ignored during
JTAG debug operations.
data_valid
1
Input
A signal arriving at this port
asserted high indicates the
data[]
port contains valid data.
This signal is ignored during
JTAG debug operations.
data_ready
1
Output
A signal arriving at this port
asserted high indicates the PR IP
core is ready to read the valid
data on the
data[]
port
whenever the
data_valid
signal
is asserted high. The data sender
must stop sending valid data if
this port is low.
This signal deasserted low
during JTAG debug operations.
UG-PARTRECON
2015.05.04
Partial Reconfiguration IP Core Ports
9
Partial Reconfiguration IP Core
Altera Corporation