Altera Arria V SoC - Manual (Page 24)

5–4 Chapter 5: Board Test System
Using the Board Test System
Arria V SoC Development Kit June 2014 Altera Corporation
User Guide
Board Information
The Board information controls display static information about your board.
■ Board Name —Indicates the official name of the board.
■ Part number —Indicates the part number of the board.
■ Serial number —Indicates the serial number of the board.
■ Factory test version —Indicates the version of the Board Test System currently
running on the board.
■ MAC1 —Indicates the MAC address of the board's ENET1 10/100 port.
■ MAC2 —Indicates the MAC address of the board's ENET2 10/100 port.
■ HPS MAC1 —Indicates the MAC address of the board's HPS 10/100/1000
Ethernet port.
■ MAX V ver —Indicates the version of MAX V code currently running on the
board. The MAX V code resides in the dir>\kits\arriaVST_5astfd5kf40es_soc\examples directory. Newer revisions of
this code might be available on the
Arria V SoC Development Kit page of the
Altera website.
JTAG Chain
The JTAG chain control shows all the devices currently in the JTAG chain. The
Arria V device is always the first device in the chain. The JTAG chain is normally
mastered by the On-board USB-Blaster II.
1 If you plug in an external USB-Blaster cable to the JTAG header (J35), the On-Board
USB-Blaster II is disabled.
1 JTAG DIP switch bank (SW4) selects which interfaces are in the chain. Refer to
Table 3–3 on page 3–4 for detailed settings.
f For details on the JTAG chain, refer to the Arria V SoC Development Board Reference
Manual. For USB-Blaster II configuration details, refer to the On-Board USB-Blaster II
page.