Altera Arria V SoC - Manual (Page 17)

Chapter 3: Board Setup and Defaults 3–7
Restoring the CFI Flash Device to the Factory Defaults
June 2014 Altera Corporation Arria V SoC Development Kit
User Guide
3. Click Add File and open
dir>\kits\arriaVST_5astfd5kf40es_soc\factory_recovery\max2_PFL_writer.pof.
4. Turn on the Program/Configure option for the Programmer Object File (.pof) file.
5. Click Start to download the selected configuration file to the MAX V CPLD.
Configuration is complete when the progress bar reaches 100%
6. Click Auto Detect and a flash device should show up attached to the MAX V in
the main window.
7. Double-click the graphic of the flash device in the device chain pane to display the
Device’s Properties dialog box.
8. Select the flash image .pof file:
dir>\kits\arriaVST_5astfd5kf40es_soc\factory_recovery\output_file.pof.
9. Once the flash image .pof is attached in the Quartus II Programmer, turn on
Page_1 and Option Bits. (Page_0 is reserved for the GSRD factory design.)
10. Click Start.
11. After the flash writing process has completed, power cycle the board and look for
the MAX CONF DONE LED to turn ON if successful.
12. Altera recommends that you return to the Max V System Controller factory design
after completing the flash writing. To do so, program the Max V with dir>\kits\arriaVST_5astfd5kf40es_soc\factory_recovery\max.pof. For
more information, refer to
“Restoring the MAX V CPLD to the Factory Settings”
on page 3–6 .
1 The flash writer version blinks the SEL 2, 1, and 0 LEDs and does not support the
Power Monitor, Clock Control, or other logic functions. It should only be used for
configuration.
f
To ensure that you have the most up-to-date factory restore files and information
about this product, refer to the
Arria V SoC Development Kit page of the Altera
website.