Altera Arria V SoC - Manual (Page 14)

3–4 Chapter 3: Board Setup and Defaults
Factory Default Switch and Jumper Settings
Arria V SoC Development Kit June 2014 Altera Corporation
User Guide
3. Set the DIP switch bank (SW4) to match Table 3–3 and Figure 3–1 .
In the following table, up and down indicates the position of the switch with the
board orientation as shown in
Figure 3–1 .
3 MSEL2
Switch 3 has the following options:
■ ON (up) = MSEL2 is 0.
■ OFF (down) = MSEL2 is 1.
ON
4 MSEL3
Switch 4 has the following options:
■ ON (up) = MSEL3 is 0.
■ OFF (down) = MSEL3 is 1.
ON
5 MSEL4
Switch 5 has the following options:
■ ON (up) = MSEL4 is 0.
■ OFF (down) = MSEL4 is 1.
ON
Table 3–3. SW4 JTAG DIP Switch Settings
Switch
Board
Label
Function
Default
Position
1 HPS
■ ON (up) = Do not Include HPS in the JTAG chain.
■ OFF (down) = Include HPS in the JTAG chain
OFF
2 FPGA
■ ON (up) = Do not Include the FPGA in the JTAG
chain.
■ OFF (down) = Include the FPGA in the JTAG chain.
OFF
3 FMCA
■ ON (up) = Do not include the FMCA connector in the
JTAG chain.
■ OFF (down) = Include the FMCA connector in the
JTAG chain.
ON
4 MAX
■ ON (up) = Do not include the MAX V system
controller in the JTAG chain.
■ OFF (down) = Include the MAX V system controller in
the JTAG chain.
OFF
Table 3–2. SW3 DIP Switch Settings (Part 2 of 2)
Switch
Board
Label
Function
Default
Position