Altera Arria V SoC - Manual (Page 10)

2–4 Chapter 2: Software Installation
Installing the USB-Blaster II Driver
Arria V SoC Development Kit June 2014 Altera Corporation
User Guide
The installation program creates the Arria V SoC Development Kit directory structure
shown in
Figure 2–1 .
Table 2–1 lists the file directory names and a description of their contents.
Installing the USB-Blaster II Driver
The Arria V development board includes integrated USB-Blaster circuitry for FPGA
programming. However, for the host computer and board to communicate, you must
install the On-Board USB-Blaster II driver on the host computer.
f Installation instructions for the On-Board USB-Blaster II driver for your operating
system are available on the Altera website. On the
Altera Programming Cable Driver
Information page of the Altera website, locate the table entry for your configuration
and click the link to access the instructions.
f For USB-Blaster II configuration details, refer to the On-Board USB-Blaster II page.
Figure 2–1. Arria V SoC Development Kit Installed Directory Structure (1)
Note to Figure 2–1 :
(1) Early-release versions might have slightly different directory names.
documents
board_design_files
The default Windows installation directory is C:\altera\ \.
examples
factory_recovery
demos
kits
arriaVST_5astfd5kf40es_soc
Table 2–1. Installed Directory Contents
Directory Name Description of Contents
board_design_files
Contains schematic, layout, assembly, and bill of material board design files. Use these files as a
starting point for a new prototype board design.
demos Contains demonstration applications.
documents Contains the kit documentation.
examples Contains the sample design files for the Arria V SoC Development Kit.
factory_recovery
Contains the original data programmed onto the board before shipment. Use this data to restore
the board with its original factory contents.