Pilz PSSu E F BSW - Manual (Page 20)

Wiring
Operating Manual PSSu E F BSW(-T)
21372-EN-05
20
Mechanical connection of the base modules
Procedure:
} Use a flat blade screwdriver (DIN 5264-A)!
DIN 5264-A
} Strip the wire back 8 mm.
} If necessary, label the connection level with a colour marker [3].
} Base module with screw terminals:
– Use a screwdriver to loosen the screw on the screw terminal [1]
– Insert the stripped cable into the round fixing hole [2], as far as it will go.
– Tighten up the screw on the screw terminal.
– Check that the cable is firmly seated.
} Base module with cage clamp terminals:
– Insert the screwdriver [4] into the square hole [1].
– Insert the stripped cable into the round fixing hole [2], as far as it will go [5].
– Pull out the screwdriver [6].
– Check that the cable is firmly seated.
21 11
[1]
[3]
[2]
6.1.1