Pilz PNOZ mm0p-T - Manual (Page 17)

Commissioning
Operating Manual PNOZ mm0p-T
1002704-EN-01
17
Load project via USB port
Procedure:
} Insert a chip card into the card slot on the base unit.
} Connect the computer containing the PNOZmulti Configurator to the base unit via the
USB port.
} Switch on the supply voltage.
} Download the project (see PNOZmulti Configurator's online help).
} Once the project has been successfully downloaded, the status of the inputs and
outputs and the supply voltage will be shown via the LEDs. The "RUN" LED is lit.
Connection
Supply voltage AC DC
For the safety system
A1 + 24 V DC
A2
0 V
For the semiconductor outputs
Must always be present, even if
the semiconductor outputs are not
used
24 V + 24 V DC
0 V 0 V
Supply voltage
Input circuit Single-channel Dual-channel
E-STOP
without detection of shorts across
contacts
S1
IM0 L+
S1
IM1
IM0 L+
L+
E-STOP
with detection of shorts across
contacts
IM0
T0M20
S1 S1
T1M21
IM1
T0M20
IM0
Connection examples for the input circuit
6.2.3.2
6.2.4