Waldorf Edition - Manual (Page 77)

Waldorf Edition
User Manual 77 Waldorf
w
Please note that a slight temporal synchronization sets in, when the oscillator
waveforms Triangle and Saw are used.
Routing Pre, Post
Routing determines, whether ring modulation sets in before (“Pre”) or after (“Post”) the
filter.
Click on an “LED”, to make the desired setting.

Pre : Ring modulation sets in before the filter. Before it reaches the filter, the audio
signal is routed from the Sample Rate reduction output to the oscillator for ring mo-
dulation. The modulated signal is then fed back into the signal flow before the filter.
As a result, the ring modulation effect does not change if you select another filter set-
ting.
 Post : Ring modulation sets in after the filter. The audio signal passes through the
Sample Rate reduction and the filter, before the filtered signal is routed to the oscilla-
tor for ring modulation. The ring modulation largely depends on the selected filter
settings. You can achieve very nice effects by setting Resonance to a relatively high
value.
Ring Mod 0%...100%
This is where you control the ring modulation signal strength.

Turn the Ring Mod dial to the left to lower the volume of the ring modulated signal.
 Turn the Ring Mod dial to the right to increase the volume of the ring modulated si-
gnal.
The Delay block
Time 0ms...2000ms
This parameter controls the delay time. Additionally you can select a pop-up menu
with often used measure units.

Turn the Time dial to the left to get a short delay time.
 Turn the Time dial to the right to get a longer delay time.
 Click on the display of the Time dial to select a pop-up menu with often used mea-
sure units and choose the desired value. The pop-up menu is only available if Tem-
po is set to a value unequal to „off“.
What is displayed in the Delay Time value field above the dial and how it is quantized
depends on the current Tempo setting in D-Pole. Values ranging from 1/ 64th triplet up
to the maximum Delay Time of two seconds are displayed in bars or beats. Shorter va-
lues, typical for Karplus & Strong effects, are displayed in milliseconds. If you need to
make your settings more freely, set Tempo to 0.