Waldorf Edition User Manual
Page 56
Waldorf Edition
User Manual
56
Waldorf
The setting 0 CENTS does not create a detuning effect, which can cause the signal
to be out of phase.
The setting 3 CENTS detunes the sub oscillator by 3 cent.
The setting 6 CENTS detunes the sub oscillator by 6 cent.
The setting 9 CENTS detunes the sub oscillator by 9 cent.
The setting 12 CENTS detunes the sub oscillator by 12 cent.
The setting 7SEMI detunes the sub oscillator by 7 7 semitones (a Fifth) upwards.
The setting 1 OCT detunes the sub oscillator by one octave upwards.
The setting 2 OCT detunes the sub oscillator by two octaves upwards.
MOD>OSC
ON, OFF
This parameter can be used to select the LFO as a modulation source for the pitch of
the main oscillator. This creates a Vibrato effect. Please keep in mind that no modu-
lation will take place, if the Modulation wheel is all the way down. The setting of
the Modulation wheel is stored with each Program, same as on the original PPG
Wave. Make sure that TOUCH>MOD in the MODULATION menu is set to OFF, ot-
herwise the LFO only modulates one signal, if Aftertouch is generated at the same
time.
MOD>SUB
ON, OFF
This parameter is identical with MOD>OSC, except that in this case the sub oscilla-
tor is pitch modulated.
ENV3>OSC
ON, OFF
You can use this parameter to select the AD-Envelope 3 as a modulation source for
the pitch of the main oscillator. You can use this to create a rising pitch in the Attack
phase, for example. Using the ENV 3 ATT dial on the analog user interface, you con-
trol, whether the deflection should be positive or negative.
ENV3>SUB
ON, OFF
You can use this parameter to select the AD-Envelope 3 as a modulation source for
the pitch of the sub oscillator. Using the ENV 3 ATT dial on the analog user inter-
face, you control, whether the deflection should be positive or negative.
BEND>PITCH
OFF, BOTH, SUB
This parameter lets you control the pitch changes that you make with the Pitch Bend
wheel.
You can make these settings:
OFF: The Pitch Bend wheel position doesn’t influence the pitch of the sound.
BOTH: The Pitch Bend wheel can be used to simultaneously change the pitch of
both oscillators.