Waldorf Edition User Manual
Page 59
Waldorf Edition
User Manual
59
Waldorf
w
To complete the picture, this parameter can also be found in the DIGITAL
menu section.
MOD>FILTER
ON, OFF
This parameter lets you use the LFO as a modulation source for the filter frequency.
Please keep in mind that the LFO modulation intensity can only be set with the Mo-
dulation wheel. Thus, no modulation will take place, if the Modulation wheel is all
the way down. The setting of the Modulation wheel is stored with each Program,
same as on the original PPG Wave. Make sure that TOUCH>MOD in the
MODULATION menu is set to OFF, otherwise the LFO only modulates one signal, if
Aftertouch is generated at the same time.
MOD>LOUDNESS
ON, OFF
If this parameter is set to ON, then the LFO will continuously modulate the level.
Please take special note that this modulation is independent of the Modulation
wheel setting. The LFO parameter DELAY doesn’t have any impact on this parame-
ter. You can use this parameter for to create a continuous Tremolo effect.
TOUCH>WAVES
ON, OFF
Provided that your Master keyboard can generate Aftertouch data, this parameter lets
you perform a Wave scan using monophonic Aftertouch (Channel Pressure).
TOUCH>FILTER
ON, OFF
Provided that your Master keyboard can generate Aftertouch data, this parameter lets
you control the deflection of the Filter Envelope – as set with the ENV 1VCF dial – by
using monophonic Aftertouch (Channel Pressure).
TOUCH>LOUDNESS
ON, OFF
Provided that your Master keyboard can generate Aftertouch data, this parameter lets
you control volume – as set with the ENV 2VCA dial – by using monophonic After-
touch (Channel Pressure).
TOUCH>MOD
ON, OFF
This parameter lets you trigger an LFO modulation with monophonic Aftertouch
(Channel Pressure). For this to have any effect, please make sure that the Modulation
wheel is not turned all the way down. If it is, this parameter has no effect.
BEND>PITCH
OFF, BOTH, SUB
This parameter lets you control the pitch changes that you make with the Pitch Bend
wheel.
You can make these settings:
OFF: The Pitch Bend wheel position doesn’t influence the pitch of the sound.
BOTH: The Pitch Bend wheel can be used to simultaneously change the pitch of
both oscillators.