Waldorf Edition - Manual (Page 42)

Waldorf Edition
User Manual 42 Waldorf
RemoteSL Control Page 3 PPG Wave 2.V Parameter
Encoder 1 KEYB MODE
Encoder 2 ARP ACTIVE
Encoder 3 ARP MODE
Encoder 4 ARP RATE
Encoder 5 ARP RANGE
Encoder 6 SEMITONE>KEY
Encoder 7 LFO SYNC
Encoder 8 TRUE PPG
Pot 1 SEMITONE 1
Pot 2 SEMITONE 2
Pot 3 SEMITONE 3
Pot 4 SEMITONE 4
Pot 5 SEMITONE 5
Pot 6 SEMITONE 6
Pot 7 SEMITONE 7
Pot 8 SEMITONE 8
Slider 1 ENV2>VCA
Slider 2 VEL>LOUDNESS
Slider 3 BASIS
Slider 4 OUT 3-4
Slider 5 ENV2 ATTACK
Slider 6 ENV2 DECAY
Slider 7 ENV2 SUSTAIN
Slider 8 ENV2 RELEASE
w
The host application must support the Novation RemoteSL and its „AutoMap“
feature to be able to control the Attack. Please read the documentation of the
corresponding host application.
PPG Wave 2.V Polyphony
The PPG Wave 2.V has up to 64 voices. The number of available voices depends on
the available processor power. The number of voices can easily be set on the Plug-In
user interface. All you have to do, is use the mouse button to increase or decrease
the value in the VOICE display. This is a global setting. It also affects all other Multi
mode channels.
You should always increase the VOICE number, if you wish to play the PPG Wave
2.V in duophonic or quadrophonic mode, or if you want to play back several sound
programs simultaneously. Find more information in the section “The Program Menu”
on page 12of this manual. Keep in mind that each additional voice demands addi-
tional calculating power from your computer. Try to set the number of voices to a
sensible value, if you simultaneously use other Plug-Ins and if you also play back
audio tracks with your host application.
w
Hint: Only voices that sound create processor load. VOICE only controls the
maximum number of simultaneously possible voices.