Waldorf Edition - Manual (Page 60)

Waldorf Edition
User Manual 60 Waldorf
 SUB: The Pitch Bend wheel is used to only change the pitch of the sub oscillator.
The main oscillator’s pitch remains unchanged.
w
This parameter can also be found on the TUNING menu.
BEND>FILTER ON, OFF
If this parameter is set On, you can control the filter frequency with the Pitch Bend
wheel. Please keep in mind that the Pitch Bend wheel is a bipolar modulation
source. It can produce both positive and negative values.
BEND>WAVES ON, OFF
This parameter lets you use the Pitch Bend wheel to perform a Wave scan. As Pitch
Bend normally snaps to a center setting, it is advisable to also set the Wave oscilla-
tor into a center setting. This lets you create a bipolar modulation. Make sure to set
WAVES-OSC to 29, as otherwise the maximum deflection of the pitch bent four ana-
log waveforms of the Wavetable are also read out.
BEND>INTERVAL 2 SEMI...1 OCT
This parameter lets you control the interval in semitones, that is created, if the Pitch
Bend wheel has its respective maximum setting. These intervals are possible:

2 SEMI means two semitones
 4 SEMI means four semitones
 7 SEMI means seven semitones (Fifth)
 1 OCT means one octave
The set interval also controls the strength of BEND>FILTER and BEND>WAVES in
similar fashion.
Graphical Editor (GRAPH)
In the Graphical Editor, you can quickly and easily edit the Envelopes and filter
response curve with the mouse. Editing is simplified by the fact that you see the gra-
phic changes in the corresponding function.
To open the graphical Editor, click on the GRAPH button. The button lights up in
red. Clicking it again lets you switch back to the analog user interface.
To edit, click on the respective handle and drag into the desired direction. The
changes and their parameter names are additionally visible in the display. Please
keep the following in mind: