StorCase Technology SCSI-to-SCSI Single RAID - Manual (Page 44)

34 Configuration
StorCase Technology, Inc. DXIFS-160/RAID User's Guide - Rev. B00
Set Date/Time
This command allows the user to set the time and date on the controller. The time and date
are used in the event log and to set the creation time stamp on the arrays.
Host Configuration
This command allows the user to set the SCSI target ID and the bridge LUN.
Channel Configuration
This command allows the user to set speed and initiator ID of the back-end SCSI disk channels
(Figure 22). Select the channel to configure and set the following:
•
Speed - this is the maximum speed the controller will attempt to negotiate
160MB/sec (DT clocking) = Default Setting
80MB/sec (ST clocking)
40MB/sec (ST clocking)
•
Initiator ID - Select the controller's Initiator ID
Figure 22: Channel Configuration