StorCase Technology SCSI-to-SCSI Single RAID - Manual (Page 23)

DXIFS-160/RAID User's Guide - Rev. B00 StorCase Technology, Inc.
Configuration 13
To find HyperTerminal in Windows:
1. Click on Start (normally located at the bottom left of the Windows desktop)
2. Go to Programs
3. Go to Accessories
4. Go to HyperTerminal
Setting Value
Terminal Emulation
Font
Translations
Columns
VT-100 or ANSI
Terminal
None
80
IFS_46
Table 1: Terminal Program Preferences
Set the preferences as follows:
Setting Value
IFS_47
Baud Rate
Data Bits
Stop Bits
Parity
Flow Control
Connector
115,200
8
1
None
None
COM1 (typical)
Table 2: Terminal Program Communications Parameters
Set the communications parameters as follows: