SpectraCal Cine-tal DAVIO - Manual (Page 6)

V1.2 2013.04.23
Configure Davio Output Source
12. On the Davio Control Outputs tab, for either SDI Out or HDMI Out (whichever is connected to the
monitor) set the Source to 3D LUT 1.
Or, from the Davio front panel
a. Right until LCD reads “SDI Out 1”
b. Down - LCD reads “SDI Out 1 Source”
c. +/- until LCD reads “3D LUT 1”
d. Right until LCD reads “HDMI Out”
e. Down - LCD reads “HDMI Out Source”
f. +/- until LCD reads “3D LUT 1”
Set the Source for SDI Out or HDMI
Out to 3D LUT