SpectraCal Panasonic DT50 - Manual

Panasonic
VT30/GT30/DT30, VT50/GT50/WT50/DT50 (EU/UK models)
CalMAN Setup Guide
CalMAN automatically calibrates the Panasonic VT30/GT30/DT30/VT50/GT50/WT50/DT50 EU/UK model
display’s two point grayscale controls, and, on VT models only, 10 point grayscale controls and CMS
colour gamut controls. The display’s two custom picture modes, ISF Day and ISF Night, can each be
calibrated with individual picture menu adjustments, grayscale adjustments, and CMS adjustments (VT
models only).
Recommended CalMAN Workflows:
GT30/DT30/GT50/WT50/DT50

HT Basic or SI Basic workflow to optimize Picture controls and calibrate two point grayscale RGB
balance controls.
VT30/VT50

HT Advanced or SI Advanced workflow to optimize Picture controls and calibrate 10 point
grayscale RGB balance controls and CMS colour gamut controls.
Recommended Test Patterns:
Plasma displays exhibit power supply luminance limiting with high brightness, high APL test patterns.
This can cause incorrect luminance measurements. To avoid this situation with plasma displays, use test
patterns with the smallest window size available from your test pattern source. Under Window Size, on
the Source Settings panel, select the smallest window size that works with your color meter.
Required Panasonic Firmware:

VT30 – 1.801

VT50 – 1.624
Panasonic Control Connection:

Ethernet straight through (standard) cable for direct connection, or

Wireless (Wi-Fi) connection
Panasonic Setup Process:
To enable ISFccc Mode:
1. In the Panasonic Setup menu, select Advanced (ISFccc).
2. Select On.
To connect the calibration computer to a VT30/GT30/DT30/VT50/GT50/WT50/DT50 with a direct
Ethernet cable: