Pitney Bowes DM550 Series - Manual (Page 105)

DM500™ and DM550™ Series Digital Mailing System Operating Guide
SV61436 Rev. D 6-5
Connecting
Your
Postage
Meter to an
Analog
Phone Line If you do not have access to a Local Area Network (LAN) connection, you
can connect to the analog phone line connector on the back of the 
IntelliLink® Control Center.
Connecting Your
Control Center to
a Remote Analog
Line In order to connect the control center to a remote analog line, you need an
A/C Adapter (P/N 1C85005).
To remove the control center and move it to another location:
1. Turn off the power to the mailing system.
2. Pull the blue lever at the right of
the control center towards you.
3. Slide the control center forward
to remove it.
4. Take the control center (and
external modem) to where the
analog phone line is.
5. Connect the telephone cord
(AWG 26) from the analog
phone line connector to the
analog telephone line.
6. Connect the A/C Adapter (P/N
1C85005) to the back of the
control center and plug it into
an AC outlet.
7. Add or check your postage funds as described in Checking Your 
Postage By Phone® Meter Payment System Account Balance
in this
chapter.
8. Reinstall the IntelliLink® Control Center by sliding it into the docking
station on top of the mailing system until you hear it click into place.
9. Turn the power back on.
2
NOTE:
If you need to connect to an analog phone line that is not located near
your IntelliLink Control Center, you can remove the control center and move it to
a location near the analog line. Refer to Connecting Your IntelliLink Control
Center to a Remote Analog Phone Line
in this chapter for more information.
Analog Phone
Line Connector
AC Adapter Receptacle
USB 
Connector