Lan set commands, Na,function[,p1] – setup smtp, Nl[,trapip,community] – setup snmp – GoDEX EZPL User Manual
Page 63: Nl,enable,n –enable or disable snmp

58
LAN Set Commands
^NA,function[,p1] – setup SMTP
Syntax
^NA,function[,p1]
Parameter
Function = ENABLE: without “p1”, it wills response SMTP enables or disables status.
With “p1”. P1 = 0 disable SMTP , = 1 enable SMTP
USER : without “p1”, it will response USER string ( login SMTP server account )
with “p1” = setup USER string
Ex. ^NA,USER,godex
PASS : without “p1”, it will response PASSWORD
with “p1” = setup PASSWORD 4 digits ( login SMTP server password )
Ex. ^NA,PASS,0000
IP : without “p1”, it will response SMTP IP address
with “p1” = setup SMTP IP address
Ex. ^NA,IP,192.168.0.1
SUBJECT : without “p1”, it will response e-mail subject
with “p1” = setup e-mail subject
Ex. ^NA,SUBJECT,error message
FROM : without “p1”, it will response e-mail sender address
with “p1” = setup e-mail sender address
Ex. ^NA,FROM,[email protected]
TO : without “p1”, it will response e-mail receiver address
with “p1” = setup e-mail receiver address
Ex. ^NA,TO,[email protected]
Description
Refer to above Parameter explanation.
Example
Procedure :
PC to Printer ^NA,USER
Printer to PC
godex
PC to Printer ^NA,SUBJECT
Printer to PC
errormessage
^NL[,TrapIP,Community] – setup SNMP
Syntax
^NL,TrapIP,Community
Parameter
Without “TrapIP,Community”, it will response SNMP setting
With “TrapIP,Community” = setup SNMP
Description
Setup SNMP or check SNMP setting
Example
Procedure :
PC to Printer ^NL
Printer to PC
192.168.0.1,public
^NL,ENABLE,n –enable or disable SNMP
Syntax
^NL,ENABLE,n
Parameter
= 0 disable ; = 1 enable this function
Description
Without “n”, it will response the status of SNMP (enable or disable)
With “n” = setup SNMP enable or disable
Example
None