Mgett,name - read saved file, Mmov,s:o.x,d:o.x - move file, Px - print label – GoDEX EZPL User Manual
Page 31: Q±x - row offset adjustment, Rx - rotate printing, Mgett,name

26
~MGETT,name
Syntax
~MGETT,name
Parameter
name = the name of saved
Description
Read the saved file from printer.
Example
Use “~MSETT, text1
Then use “~MGETT,name
Example:
~MGETT,text1
Hyper Terminal will show:
Text file test2
~MMOV,s:o.x,d:o.x - Move file
Syntax
~MMOV,s:o.x,d:o.x
Parameter
s = source device of stored object ( s = D or F )
d = distination device of stored object
o = object name , o also can use * for this command.
x = extension , x also can use * for this command.
= D, database
= A, Asia font
= C, TTF font
= E, Bit-Mapped font
= F, label form
= G, graphic
= S, serial file
= T, text
= B, Unicode Table
Description
Move file
Example
~MMOV,F:*.F,D:*.F
~MMOV,D:*.G,F:
~Px - Print label
Syntax
~Px
Parameter
x = 1 ~ 32767
Description
This command will repeatedly print the specific copies of label format.
~Q±x - Row Offset Adjustment
Syntax
~Q±x
Parameter
X =-100 ~ +100 (unit: dots)
Description
This command is used for setting the start position of label printing. The top edge of
label is considered as “0”. The “+n” move the start position downward, and the “–n”
move the position upward (it can be set across 2 labels).
~Rx - Rotate printing
Syntax
~Rx
Parameter
x = label width (unit: mm), the input range is defined by the specification of printer
models.
Description
Rotate the label format 180-degrees when printing (refer to page75). To return to
the original print direction, set the x value greater than the max width of model’s
specification.