Eurocom M980NU XCaliber - Manual (Page 130)

Modules
7 - 12 RAID Setup
7
The NVIDIA Storage Control Panel
The NVIDIA Storage control panel may be used to rebuild, migrate or synchro-
nize the array.
Rebuilding the Array
1. Run the Nvidia control panel from Start > Programs/All Programs > NVIDIA
Corporation > NVIDIA Control Panel > Storage (choose Advanced or Standard).
2. Click Storage from the left window.
3. Click on Rebuild Array and then click Next and a wizard will take you through the
necessary steps.
4. Click to select the RAID and click Next.
Rebuilding the
Array
The wizard will help you
rebuild one of the arrays
member disks and it will
run in the background.
You can continue to use
the computer while the
rebuild is in process, but
it may take up to a day to
complete.
Make sure you turn off
all power-saving set-
tings e.g. Standby or Hi-
bernate when rebuilding
the array as the process
will be suspended while
power-saving modes
are in operation.
Figure 7 - 10
Select RAID
Rebuilding
Automatically
Rebuilding restores data
to a hard drive from one of
the other drives in the ar-
ray. This will occur auto-
matically if a spare disk is
available.