Upgrading the video card, Upgrading the video card -14 – Eurocom M980NU XCaliber User Manual
Page 112

Upgrading The Computer
6 - 14 Upgrading the Video Card
6
Upgrading the Video Card
If you intend to upgrade or add another VGA card follow the procedures outlined
here. However please check with your service representative first to make sure your
computer can support more than one video card, and that you are not going to void
your warranty. Pay careful attention to the alignment of any video card into the slot
on the mainboard.
1.
Turn off the computer, and turn it over and remove the battery.
2.
Locate the component bay cover and remove screws
-
3.
Carefully (a fan and cable are attached to the under side of the cover) lift up
the bay cover.
4.
Carefully disconnect the fan cable
, and remove the cover
.
Warranty Warning
Please check with your
service representative
before undertaking any
upgrade procedures to
find out if this will VOID
your warranty.
Figure 6 - 15
Bay Cover Screws &
Bay Cover Removal
Fan Cable
Make sure you recon-
nect the fan cable
before screwing down
the bay cover.
6
1
5
6
7
1
3
2
4
5
6
7