Setting up sata raid or ahci modes, Ahci mode, Raid – Eurocom M980NU XCaliber User Manual
Page 120: Setting up sata raid or ahci modes -2, Ahci mode -2 raid -2, Operating system. see, Setting up sata raid or, For configur

Modules
7 - 2 Setting Up SATA RAID or AHCI Modes
7
Setting Up SATA RAID or AHCI Modes
AHCI Mode
Advanced Host Controller Interface (AHCI) is an interface specification that allows
the storage driver to enable advanced serial ATA features such as Native Command
Queuing (for maximum hard disk efficiency and performance). AHCI mode can be
supported by one or two hard disks.
RAID
You may use your hard disks (if you have included more than one hard disk in your
purchase option) in combination with Striping (RAID 0) or Mirroring (RAID 1) for
either fault tolerance or performance (see
). To configure
your system in Striping (RAID 0) or Mirroring (RAID 1) modes you will require at
least two hard disks.
SATA Mode
Selection
If you have installed the
Windows Vista operat-
ing system with either
AHCI or RAID mode en-
abled, DO NOT disable
the set mode (if you wish
to disable the set mode
you will need to reinstall
the Windows VIsta OS).