Raid mode setup, Raid mode setup -5, 7raid mode setup – Eurocom M980NU XCaliber User Manual
Page 123: Is selected as the o/s, Modules raid setup 7 - 5, Figure 7 - 1, Only available if windows vista

Modules
RAID Setup 7 - 5
7
RAID Mode Setup
1.
Start-up your notebook computer and press <F2> to enter the BIOS.
2.
Go to the Advanced menu, select “SATA Mode Selection” and press Enter (see
page
5 - 7
).
3.
Select “RAID” or “AHCI”.
4.
Press Esc and go to the Boot menu.
5.
Set the CD/DVD-ROM Drive (make sure the Microsoft Windows OS CD is
inserted) as the first device in the boot order from the Boot menu.
6.
Select Exit Saving Changes from the Exit menu (or press F10 and Enter) and
press Enter to exit the BIOS and reboot the computer.
Figure 7 - 1
BIOS > Advanced
(SATA Mode
Selection)
Main
A
Advanced
Security
Boot
Exit
F1
Help
Select Item
- / +
Change Values
F9
Setup Defaults
Esc
Exit
Select Menu
Enter
Select
Sub-Menu
F10
Save and Exit
Item Specific Help
Advanced
Determines how SATA
controller(s) operate.
Note: An incorrect
setting can cause
some operating
systems to display
unexpected behavior.
Phoenix SecureCore(tm) Setup Utility
Integrated Devices
Installed O/S:
[Windows VISTA]
SATA Mode Selection:
[
RAID
]
Legacy USB Support:
[Enabled]
Boot-time Diagnostic Screen:
[Disabled]
Power On Boot Beep
[Disabled]
Battery Low Alarm Beep:
[Disabled]
Only available if Windows Vista
is selected as the O/S.