Ditch Witch JT20 - Manual (Page 28)

JT20 Operator’s Manual
Controls - 27
Set-Up Console
CMW
®
2. Cold start wait indicator Lights when intake air pre-
heater is operating.
Wait until light goes off before
starting engine.
3. Ignition switch To start engine, insert key and
turn clockwise.
To stop engine, turn key
counterclockwise.
Restart engine with ignition switch
after it has been turned off with
remote engine stop switch.
If wrenches are engaged when
engine is stopped with ignition switch,
wrenches will release and then
engage when unit is started.
4. Left track switch To move forward, press top.
To move backward, press
bottom.
Use track switches only if tethered
control is inoperable.
5. Right track switch To move forward, press top.
To move backward, press
bottom.
Use track switches only if tethered
control is inoperable.
6. Engine shutdown
override switch If engine shutdown indicator
comes on, press to delay
engine shutdown for 30
seconds. This control allows a temporary
override of engine shutdown.
NOTICE: After 30 seconds, engine
will again shut down unless fault
condition has been cleared on
diagnostic gauge. See “Electronic
Controlled Engine Overview” on
page 144.
Item Description Notes
c00ic147h.eps
c00ic148h.eps
c00ic178h.eps