Ditch Witch JT20 - Manual (Page 160)

JT20 Operator’s Manual
Service - 159
Recommended Lubricants/Service Key
CMW
®
Recommended Lubricants/Service Key
Item Description
DEO
(Tier 4
Units) Diesel engine oil meeting or exceeding Deutz specification DQC III- LA.
NOTICE: This unit is shipped from the factory with API CJ-4 DEO meeting Deutz
specification DQC II-LA. Change oil initially at 250 hours.
• Engine must use low sulfated ash, phosphorous, and sulfur (low (SAPS) oil.
• See viscosity chart.
• If oils meeting only API CJ-4 or ACEA E6/E9 are used, service interval is reduced
to 250 hours.
DEO
(Tier 4i
Units) Diesel engine oil meeting or exceeding Deutz specification DQC III.
NOTICE: Shipped from factory with API CJ-4 DEO meeting Deutz specification DQC II-
LA. Change oil initially at 100 hours if fuel sulfur level content exceeds 500 ppm (500
mb/kg). Otherwise initial oil change should be at 250 hours.
• See viscosity chart.
• If oils meeting only API CJ-4 or ACEA E7 are used, service interval is reduced to
250 hours.
NDO SAE 30 Non-detergent oil
MPG Multipurpose grease. Use polyurea based NLGI GC-LB Grade 1.5 or lithium based
NLGI GC-LB Grade 2.
EPG Open gear extreme pressure lubricant (p/n 256-666)
EPS Open gear extreme pressure lubricant, spray (p/n 256-034)
MPL Multipurpose gear oil meeting API service classification GL-5 (SAE 80W90)
THF Tractor hydraulic fluid, similar to Phillips 66 HG, Mobilfluid 424, Chevron Tractor
Hydraulic Fluid, Texaco TDH Oil, or equivalent
TJC
Tool joint compound: Ditch Witch
®
standard (p/n 259-858), environmentally friendly
(257-1005), or summer grade (p/n 256-031)
DEAC Diesel engine antifreeze/coolant meeting ASTM D6210 (fully formulated)
Check level of fluid or lubricant
Check condition
Filter