Ditch Witch JT20 - Manual (Page 155)

Complete the Job - 154
JT20 Operator’s Manual
Rinse Equipment
CMW
®
Rinse Equipment
Using Washwand
1. Connect the washwand at quick connect (1) at rear
of unit. Open valve (2) to start water flow. Close
valve to stop water flow.
2. Spray water onto equipment to remove dirt and
mud. Some pressure might be needed to remove
dried mud from wrench area.
Disconnect
Disconnect and store the following hoses and cables (if
used):
• electric strike system voltage stake
• fluid hose
Stow Tools
Make sure all quick wrenches, bits, pullback devices, and other tools are loaded and properly secured on
trailer or truck.
Pressurized fluid or air could pierce skin and cause injury
or death. Stay away.
To help avoid injury:
• Never use high flow when using washwand.
• Prime the drilling fluid pump before operating washwand. Failure to prime the drilling fluid pump will
cause flow fluctuations, which will make it difficult to control the washwand. For instructions, see
“Prime Drilling Fluid Pump” on page 90.
NOTICE: Do not spray water onto operator’s console. Electrical components could be damaged. Wipe
down instead.