Dillon Precision SL 900 - Manual (Page 37)

5. Return the roller handle to the up position.
6. Use a 1/4" Allen wrench to unscrew the
shellplate bolt.
7. Remove the shellplate from the machine.
8. Change the locator buttons. First, remove the
locator buttons by pressing and holding the locator
button down. Reach below the platform and rotate
the locator button until it snaps free. Fig. 4 Remove all
three locator buttons. Next, retrieve the new locator
buttons from the 28 gauge conversion box. Place the
spring on the locator button, place it in the platform,
press down and rotate as needed to allow the locator
button to snap into place. Fig. 4a
9. At Station 2, place the green locator insert (28
gauge) onto the Station 2 locator. Fig. 5
10. Move the roller handle to the down position.
11. Place the 28 gauge shellplate on the
platform. Fig. 6
12. Insert the shellplate bolt. Use a 1/4" Allen
wrench to thread the shellplate bolt down until it
stops, then loosen no more than 1/4 of a turn.
13. Use a 1/8" Allen wrench to secure the 1/4-28
brass tip set screw. Do not over-tighten
14. Reinstall the ejector wire (#16676). Fig. 7
15. Return the roller handle to the up position.
Fig. 6
Fig. 5
Fig. 4a
Fig. 4
37
SL 900, May 2007 5/21/07 11:51 AM Page 37