Dillon Precision SL 900 - Manual (Page 35)

The Primer System:
The primer feed system on the SL 900 machine is
a fully mechanical system. Every complete stroke of
the roller handle (#22183) will feed a new shotshell
primer into the machine. Fig. 80 Two very important
but simple points:
#1. Always keep the machine and its primer feed
system clean and free of dirt. Do not place any oils or
grease on the primer feed plate. This hinders the free
flowing operation of the system.
#2. Never allow excess powder or dirt to build up
on the deck where the primer transfer arm (#16691)
swings in and out of the machine.
If you decide to service your machine or don’t
wish to have any primers feeding, install the “stop
block” into the primer system as shown. When you’re
ready to resume, simply remove the “stop block” and
the primers will begin feeding again the next time you
cycle the handle.
35
Fig. 81 Fig. 80
SL 900, May 2007 5/21/07 11:51 AM Page 35