Chicago Gaming Medieval Madness Remake - Manual (Page 43)

Press the Up or Down buttons to scroll through the Test menu. Press the Enter button to access a test.
Press the Escape button to return to the Test menu. During any test, press the Start button to obtain the
wire color, driver number , connector numbe r and fuse location .
T. TEST MENU
T.1 Switch Edges Test
T.2 Switch Levels Test
T.3 Single Switch Test
T.4 Solenoid Test
T.5 Flasher Test
T.6 General Illumination Test
T . 7 Sound & Music Test
T.8 Single Lamps Test
T.9 All Lamps Test
T.10 Lamps And Flasher Test
T.11 Display Test
T.12 Flipper Coil Test
T.13 Ordered Lamps Test
T.14 Lamp Row-Col.
T.15 DIP Switch Test
T.16 Loop/Gate Test
T.17 Tower Test
T.18 Drawbridge Test
T.19 Castle Gate Test
T.20 Trolls Test
T.21 Empty Balls Test
T.1 SWITCH EDGES TEST
T.2 SWITCH LEVELS TEST
This test automatically cycles through al l switches that are detected closed. The name and
number of each switch tha t is detected is shown in the display. A filled square indicates the
switch ' s position. To return to the Test menu , p r ess the Escape button.
T . 3 SINGLE SWITCHES TEST
This test isolates a single switch and shows its state in the display. A mechanical switch is
'made' w
h en the display reads closed. An opto switch is 'made' (opto beam broken) when the
display r eads open . Use the Up or Down button s to selec t the switch to be tested . To return to
the Test menu, press the Escape button .
Press each of the switches one at a time. The name and number of the switch is shown in the
display. If a switch other than the one pressed
, o r no switch at all i s indicated , the system has
detected a problem with the switch circuit. To return to the Test menu,pressthe Escape button.
1-19
In order to operate the tests that use the +50V circuit, pull the top interlock switch
button out. The interlock switches are located on a bracket just inside the coin
door opening.