Chicago Gaming Medieval Madness Remake - Manual (Page 27)

TOP NOTCH
PINS
BOTTOM NOTCH
1-3
4. Reach into the cabinet and backbox and ensure that the interconnecting cables are not kinked
or pinched. Be careful to avoid damaging wires at any stage of the assembly process.
5. Raise the hinged backbox upright and latch it into position.
BOTTOM NOTCH
TOP NOTCH
PINS
CAUTION
FAILURE TO INSTALL the backbox mounting hardware properly can cause personal injury.
NEVER TRANSPORT a pinball game with the hinged backbox erect. Always lower the backbox
forward onto the playfield cabinet on a layer of protective material to prevent marring or damage
and possible personal injury.
6. After the wing-head mounting bolts are installed, replace the speaker panel and the
backglass/insert panel. Lock the backbox.
Note: You have the option of removing the speaker panel completely. Lay the speaker panel on the
playfield glass. Unplug the
HDMI display cable, speaker cable, monitor power cable, and monitor
keyboard cable. Line up the bottom notches with the bottom backbox pins. Lower the speaker
panelthrough the notches and slide it under the backbox pins.
Note: The insert panel is no longer hinged to the backbox; it is attached to the backglass. The
backglass and the insert panel are removed from the backbox housing as a single unit.
Unlock the backbox. Carefully, lift the backglass/insert panel from the bottom and slide it out of the
backbox. Lay it down on the playfield glass. Unplug the
insert panel cable from the controller
PCB. Carefully, set the backglass/insert panel aside.
Carefully lift the speaker panel so that the top notches clear the top pins. Rotate it away from the
backbox and toward the playfield glass. The bottom of the speaker panel remains attached to the
backbox unit.
Connector for Insert Panel
Note: The speaker panel uses a new hinging system. The bottom of the speaker panel remains
attached to the backbox unit when released.
WING BOLTS &
WASHERS
Lowering the speaker panel allows access to the holes for the bolts used to secure the backbox
upright. Install one washer-head mounting bolt
with washer a through each hole and into the
threaded fasteners in the cabinet.