Digi X2 User Manual
Connectport ™ x family user’s guide
Table of contents
Document Outline
- Contents
- About this guide
- Introduction
- ConnectPort X Family products
- Features
- User interfaces
- Quick reference for configuring features
- Hardware features
- Network interface features
- Configurable network services
- IP protocol support
- Serial data communication over TCP and UDP
- Dynamic Host Configuration Protocol (DHCP)
- Auto-IP
- Simple Network Management Protocol (SNMP)
- Secure Sockets Layer (SSL)/Transport Layer Security (TLS)
- Telnet
- Remote Login (rlogin)
- Line Printer Daemon (LPD)
- HyperText Transfer Protocol (HTTP) HyperText Transfer Protocol over Secure Socket Layer (HTTPS)
- Internet Control Message Protocol (ICMP)
- Point-to-Point Protocol (PPP)
- Network Address Translation (NAT)/Port Forwarding
- Advanced Digi Discovery Protocol (ADDP)
- Generic Routing Encapsulation (GRE) Passthrough Encapsulating Security Payload (ESP) ESP Passthrough
- Mobile/Cellular features and protocol support
- Provisioning wizard
- Digi SureLink™
- Mobile/Cellular protocols
- Global System for Mobile communication (GSM)
- Code-Division Multiple Access (CDMA)
- General Packet Radio Service (GPRS)
- Enhanced Data Rates for GSM Evolution (EDGE)
- Universal Mobile Telecommunications Service (UMTS)
- Evolution-Data Optimized (EV-DO, EVDO, or 1xEV-DO)
- IP address assignment alternatives
- RealPort software
- Alarms
- Modem emulation
- Security features
- Configuration management
- Customization capabilities
- Supported connections and data paths in Digi devices
- Configuration capabilities and interfaces
- Monitoring capabilities and interfaces
- Administration tasks
- Configure Digi devices
- Default IP address
- Alternate methods for assigning an IP address
- Configuration through the web interface
- Open the web interface
- Organization of the web interface
- Change the IP address from the web interface, as needed
- Configure network communications
- Alternatives for configuring network communications
- IP settings
- DHCP server settings
- Network services settings
- Dynamic DNS update settings
- IP filtering settings
- IP forwarding settings
- Socket tunnel settings
- IP pass-through settings
- Virtual Private Network (VPN) settings
- Uses for VPN-enabled Digi devices
- Example VPN configuration
- How VPN tunnels work
- IP address requirements for VPN tunnels
- GSM GPRS/EDGE APN type needed
- CDMA carrier requirements
- HQ router / VPN appliance configuration
- Using a console port
- Configure VPN settings
- Manual-keyed IPSEc/ESP VPN tunnel security settings
- ISAKMP VPN tunnel security settings
- VPN tunnel proposal configuration for ISAKMP tunnels
- Advanced network settings
- Configure mobile (cellular) settings
- Information required from mobile service provider
- Different processes used for CDMA and GSM provisioning
- Set mobile configuration settings to factory defaults
- Mobile service provider settings
- Provision a mobile device
- Mobile connection settings
- Digi SureLink™ settings
- Status and statistical information for mobile connections
- Configure Mesh/ZigBee network settings
- Configure serial ports
- Configure camera settings
- Configure alarms
- Configure system settings
- Configure remote management (Connectware Manager) settings
- Configure Security settings
- Configure applications
- Configuration through the command line
- Configuration through Simple Network Management Protocol (SNMP)
- Configuration through Connectware Manager
- Batch capabilities for configuring multiple devices
- What’s next?
- Monitor and manage Digi devices
- Monitoring capabilities in the web interface
- Display system information
- Manage connections and services
- Monitoring capabilities from the command line
- Monitoring capabilities from Connectware Manager
- Monitoring Capabilities from SNMP
- Monitoring capabilities in the web interface
- Administration tasks
- Administration from the web interface
- Administration from the command-line interface
- Specifications and certifications
- Glossary
- Index