Digi X2 - Manual (Page 167)

1 6 7
C o n f i g u r e D i g i d e v i c e s
Here are some examples of commands used to configure Digi devices. See the
Introduction of the Digi Connect Family Command Reference for a complete list of
features and tasks that can be configured and performed from the command line.
To configure: Use this command:
access control (IP filtering): limit network access
to device
set accesscontrol
alarms set alarms
autoconnection behaviors for serial port
connections
set autoconnect
Connectware Device Protocol connection
settings
set mgmtconnection
Connectware Device Protocol global settings set mgmtglobal
Connectware Device Protocol network settings set mgmtnetwork
Ethernet communications parameters set ethernet
IP forwarding set forward
host name set host
Industrial Automation/Modbus set ia
Mesh network settings
set mesh
(See command syntax on page 202.)
mobile statistics display mobile
modem emulation set pmodem
network options set network
network services set service