Digi X2 - Manual (Page 218)

A d m i n i s t r a t i o n f r o m t h e c o m m a n d - l i n e i n t e r f a c e
2 1 8
Administration from the command-line interface
Administrative tasks for Digi devices can also be performed from the command line. Here
are several device-administration tasks and the commands used to perform them. See the
Digi Connect Family Command Reference for more complete command descriptions.
Administrative task Command
Backup/restore a configuration from a
TFTP server on the network
backup
Update firmware boot
Telnet to the Digi device's command line
interface using a telnet application or
hyperterm.
If security is enabled for the Digi device, a
login prompt is displayed. The default
username is “root” and the default password is
“dbps.” If these defaults do not work, contact
the system administrator who set up the
device.
Issue the command:
#> boot load=tftp-server-ip:filename
where tftp-server-ip is the IP address of the
TFTP server that contains the firmware, and
filename is the name of the file to upload.
Reset configuration to factory defaults revert
or
boot action=factory
Display system information and statistics info
Reboot the device boot
Enable/disable network services set service