Digi X2 - Manual (Page 202)

M o n i t o r i n g c a p a b i l i t i e s f r o m t h e c o m m a n d l i n e
2 0 2
Commands for managing Mesh networks and nodes
Several commands are used to configure Mesh networks and display information and
statistics about the devices in the Mesh network: set mesh, display mesh, and info
zigbee_sockets.
set mesh
The set mesh command configures Mesh network settings for a ConnectPort X gateway.
Also displays current configuration parameters on the gateway Mesh node or of remote
nodes in the mesh (specified by the address option).
Configure Mesh network settings: command syntax
set mesh [options...] [device_settings...]
options:
state={off|on} {Enable mesh gateway}
address=device address {Specify device to set}
device_settings:
pan_id=0x0-0x3fff
{PAN identifier}
dest_addr=address {Destination address}
delay_slots=0-3 {Random delay slots}
broadcast_hops=0-10 {Broadcast radius}
scan_channels=0x1-0xffff {Scan channels, bitfield}
scan_duration=0-7 {Scan duration, exponent}
join_time=0-255 {Node join time, sec}
join_notification=0-2 {Join notification}
node_id=0-20 chars {Node identifier}
discover_timeout=0-252 {Node discovery timeout, x 100 msec}
aggregation=0-255 {Aggregation route notification, x 10 sec}
power_level=0-4 {Transmit power level}
power_mode=0-1 {Power mode}
cca_threshold=36-80 {CCA threshold, -dBm}
sleep_period=32-2800 {Cyclic sleep period, x 10 msec}
device_type=0x0-0xffff {Device type identifier}
serial_rate=0-115200 {Serial interface data rate}
serial_parity=0-4 {Serial interface parity}