ADLINK PCI-8158 - Manual (Page 20)

10 Installation
2.2 PCI-8158 Outline Drawing
Figure 2-1: PCB Layout of the PCI-8158
X
P1 / P2: Input / Output Signal Connector (100-pin)
X
K1 / K2: Simultaneous Start / Stop Connector
X
P3: Manual Pulsar
X
S1: DIP switch for card index selection (0-15)
X
J1-J16: Pulse output selection jumper (Line Driver / Open
Collector)
2.3 PCI-8158 Hardware Installation
2.3.1 Hardware configuration
The PCI-8158 is fully Plug and Play compliant. Hence memory
allocation (I/O port locations) and IRQ channel of the PCI card are
assigned by the system BIOS. The address assignment is done
on a board-by-board basis for all PCI cards in the system.