Delta N028314 - Manual (Page 8)

8
Fig. d-1 Fig. d-2
MINIMUM gAUgE EXTENSION CORd
RECOMMENDED SIZES FOR USE WITH STATIONARY ELECTRIC MACHINES
Ampere Total Length gauge of
Rating Volts of Cord in Feet Extension Cord
0-6 120 up to 25 18 AWg
0-6 120 25-50 16 AWg
0-6 120 50-100 16 AWg
0-6 120 100-150 14 AWg
6-10 120 up to 25 18 AWg
6-10 120 25-50 16 AWg
6-10 120 50-100 14 AWg
6-10 120 100-150 12 AWg
10-12 120 up to 25 16 AWg
10-12 120 25-50 16 AWg
10-12 120 50-100 14 AWg
10-12 120 100-150 12 AWg
12-16 120 up to 25 14 AWg
12-16 120 25-50 12 AWg
12-16 120
GREATER THAN 50 FEET NOT RECOMMENDED
MINIMUM gAUgE EXTENSION CORd
RECOMMENDED SIZES FOR USE WITH STATIONARY ELECTRIC MACHINES
Ampere Total Length gauge of
Rating Volts of Cord in Feet Extension Cord
0-6 240 up to 50 18 AWg
0-6 240 50-100 16 AWg
0-6 240 100-200 16 AWg
0-6 240 200-300 14 AWg
6-10 240 up to 50 18 AWg
6-10 240 50-100 16 AWg
6-10 240 100-200 14 AWg
6-10 240 200-300 12 AWg
10-12 240 up to 50 16 AWg
10-12 240 50-100 16 AWg
10-12 240 100-200 14 AWg
10-12 240 200-300 12 AWg
12-16 240 up to 50 14 AWg
12-16 240 50-100 12 AWg
12-16 240
GREATER THAN 100 FEET NOT RECOMMENDED
EXTENSION CORdS
Use proper extension cords. Make sure your extension cord is in good condition and is a 3-
wire extension cord which has a 3-prong grounding type plug and matching receptacle which will accept the
machine’s plug. When using an extension cord, be sure to use one heavy enough to carry the current of the
machine. An undersized cord will cause a drop in line voltage, resulting in loss of power and overheating. Fig.
d-1 or d-2, shows the correct gauge to use depending on the cord length. If in doubt, use the next heavier
gauge. The smaller the gauge number, the heavier the cord.
FOREWORd
The DELTA 10" (254 mm) Hybrid saw (36-714) has a powerful 1-3/4 HP induction motor that can handle tough cutting
operations. This table saw has a maximum depth of cut of 3-1/8" (79 mm) at 90° and 2-1/8" (54 mm) at 45°. The maximum
dado width with this saw is 13/16" (21 mm). The saw comes with two cast-iron extension sings, one of three fence systems,
see-through blade guard and splitter, throat plate, equipment mounting hooks, a 10" (254 mm) diameter blade, dust port for
4" (101.6 mm) hose amd miter gauge.
NOTICE: The illustration on the manual cover illustrates the current production model. All other illustrations contained in the
manual are representative only and may not depict the actual labeling or accessories included. These are intended to illustrate
technique only.
FUNCTIONAL dESCRIPTION
NOTICE
AVIS
AVISO
fr
sp