Delta N028314 - Manual (Page 16)

16
A
B
C
1. Install the fence holders (A) Fig. 31 using four 1/4-20 x
3/8" (9.5 mm) round head tap screws.
2. Install the wrench hook (B) using two M4 x 8 mm self-
tapping screws.
Attach the dust port (D) Fig. 33 using four 1/4-20 x 3/8"
(9.5 mm) self-tapping screws.
Make sure that the throat plate (A) is always
level with the table.
Place a straight edge (B) Fig. 30 across the table at both
ends of the throat plate (A).
To adjust, loosen the screw (D) Fig. 30 and turn the adjusting
screws (C) Fig. 30 with the supplied hex wrench.
AdJUSTINg THROAT PLATE
A
C
B
C
Fig. 30
Fig. 31
Fig. 33
INSTALLINg THE TOOL HOLdERS
B
A
INSTALLINg dUST PORT
Place a flat washer (A) Fig 34 on the threads of the miter
gauge lock handle (B). Thread the handle into the hole (C)
in the miter gauge bar.
Insert the plate (D) (Inset) into the miter gauge slot (E). Slide
the miter gauge on the saw table.
ASSEMBLINg THE MITER gAUgE
d
E
d
Fig. 34
d
disconnect the machine from the power
source!
disconnect the machine from the power
source!
disconnect the machine from the power
source!
disconnect the machine from the power
source!