Delta N028314 - Manual (Page 15)

15
1. Raise the saw blade arbor to its maximum height.
Attach the saw blade (C) Fig. 25 to the saw arbor with
the teeth of the blade pointing down toward the front of
the table (Fig. 25). Attach the flange (D) and arbor nut
(E) to the saw arbor. Tighten the arbor nut (E) by hand
with the saw blade against the inner blade flange.
2. Place the open end wrench (F) Fig. 25 on the flats of the
saw arbor and tighten the arbor nut (E) with the other
wrench (G). Turn the arbor nut clockwise.
Use a straight edge to check the alignment of the saw
blade (B) with the rear of the splitter (G) in Figs. 26 and
27. If alignment is necessary, loosen the screws (A) Fig. 28
that hold the splitter bracket to the rear trunnion. Align the
splitter (G) Fig. 26 with the saw blade and tighten two bolts
(A) Fig. 28.
Lower the saw blade and install the throat plate (P) Fig. 29
in the saw table.
IMPORTANT: When installing the throat plate, hold the
blade guard (M). After insertion, the insert will automatically
release the holding action of the splitter and lower the blade
guard.
Secure the insert with the M5 x 20 mm screw in the hole
(N).
ATTACHINg A SAW BLAdE
ALIgNINg THE SPLITTER WITH THE BLAdE
d
E
g
C
F
B
g
A
B
g
INSTALLINg THROAT PLATE
M
P
N
Fig. 25
Fig. 26
Fig. 27 Fig. 28
Fig. 29
disconnect the machine from the power
source!
disconnect the machine from the power
source!
disconnect the machine from the power
source!