STIEBEL ELTRON DHB-E 13 SL - Manual (Page 21)

OPERATION
SAFETY
2. Safety
2.1 Correct use
This appliance is ii pressure deviceforthe heating of cdd water to
DIN 19S8 that can supply one or several draw-cFf points.
Any other use beyond that described shall be deemed inappropriate.
Observation of these instructions is also part ofthe correct use of
the appliance. Any changes or conversions to the appliance void
any warranty.
2.2 Safety instructions
Observe the following safety information and instructions.
Only heating contractors should install and commission the
appliance.
The contractor is responsible for adherence to all currently
applicable regulations during installation and commissioning.
Operate this appliance only if it is fully installed and all safety
equipment is h'tted.
Risk of scalding
There is a risk of scalding at outlet temperatures in
excess of ^3
Risk of injury
Where children or persons with limited physical,
sensory or mental capabilities are to be allowed to
CO ntro I th is a ppiian ce. e ns u re th at this wi 11 on ly happen
under supervision or after appropriate instructions by
a person responsible for their safety.
Children should be supervised to ensure that they do
not play with the appliance.
Risk of damage
Do not operate the appliance following an interruption
to the water supply. This can destroy the bare wire
heating system. Run water for at least a minute before
restarting (he appliance (see chapter "What to do
if...-).
A
2.S CE designation
The CE designation shows that the appliance meets all the essential
requirements:
-Electromagnetic Compatibility Directive (Ccuncil Directive
20Qi*/10S/EC)
-Lew Voltage Directive (Council Directive 2006/95/EC)
3. Appliance description
The appliance heats water as it flews through it. The DHW outlet
temperature can be infinitely adjusted with the temperature
selector. From a certain flow rate, the control unit regulates the
correct heating output, subject tc the temperature selection and
the cold watertemperature.
The appliance is equipped with an air detector that largely prevents
damage to the heating system. Ifairisdrawn in during operation,
the appliance shuts down For one minute, thereby protecting the
heating system.
кЛ Temperature selector
Temperature selector
cn
_l
i
1Э
I approx. 30 ’’C
7 approx. 60 “C
The selector lets you freely choose the required temperature.
Should the outlet temperature fail to reach the required level with
the draw-off valve fully open and the temperature selector set
to maximum (temperature selector turned fully clockwise), then
more water flows through the appliance than can be heated by
the heating element.
» Reduce the flow rate with the draw-off valve.
<».2 Draw-off capacifies
Subject to season, varying maximum mixed water or draw-off
capacities result from different cold water temperatures. Further
information can be found in the chapter "Specification".
кЛ Therrnostatic valve
We recommend adjusting the appliance to the maximum
temperature setting "7" (temperature selector turned Fully
clockwise).
kA Temperature limit/Anti-scalding protection
The maximum outlet temperature ferthe appliance can be limited
to A3 Refer in this case to your local heating contractor.
S. Cleaning, care and maintenance
» Never use abrasive or corrosive cleaning agents. A damp cloth
is sufficient for cleaning the appliance.
Maintenance work, such as checking the electrical safety, must
only be carried out by a heating contractor.
www.stiebeL-eltron.com DHB-E ... SLi eLectronic | 21