Manual tuning, When an fm stereo broadcast contains noise, To change the am tuning interval – Aiwa XR-M35 User Manual

Page 8: To search for a station quickly (auto search), I .’.j o.lj l.j s

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

MANUAL TUNING

•BAND/

MODE

TUNER

■SHIFT

1 Press the TUNER/BAND button repeatedly to

select the desired band.

If the power Is turned off, the previously tuned station will be

played (Direct Play Function).

When using the remote control, press the BAND/MODE

TUNER button repeatedly while power is on.

2 Press the ◄◄ or ►► button to select a station.

Each time the button is pressed, the frequency changes.

When a station is received, TUNE is displayed for a moment.

During FM stereo reception, (li®)l) is displayed.

When an FM stereo broadcast contains noise

Press the BAND/MODE TUNER button while pressing the SHIFT

button on the remote control.

“MONO” appears on the display.

Noise is reduced, although reception is monaural.

:'i //

! !

... ....

; /

; ;

MONO

To restore stereo reception, repeat the above again.

To change the AM tuning interval

The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocafion system
is 9 kHz/step, change the tuning interval.

While pressing the TUNER/BAND button, press the POWER

button.

To reset the interval, repeat this procedure.

NOTE

When the AM tuning interval is changed, all preset stations (see

“PRESETTING STATIONS”) are cleared. The preset stations
have to be set again.

; / ; ; .; ; / ;

i .’.J O.LJ L.J s

To search for a station quickly (Auto Search)

Keep the ◄◄ or ►► button pressed until the tuner starts

searching for a station. After tuning in to a station, the search

stops.
To stop the Auto Search manually, press the ◄◄ or ►► button.

• The Auto Search may not stop at stations with very weak

signals.

ENGLISH