General there is no sound, Tuner section, Cassette deck section the tape does not run – Aiwa XR-M35 User Manual
Page 21: Cd player section the cd player does not play, To reset, Troubleshooting guide parts index
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TROUBLESHOOTING GUIDE
PARTS INDEX
if the unit faiis to perform as described in these Operating
instructions, check the foiiowing guide.
GENERAL
There is no sound.
• is the AC cord connected properiy?
• is Ihere a bad connection?
{-*
page 3)
• Was an incorrect function button pressed?
The sound becomes inaudible or the unit is turned off
sudifenly.
• There may be a short circuit in the speaker terminais.
-+ Disconnect the AC cord from the AC outiet and re-connect
the speaker cords correctiy. Then connect the AC cord and
turn the unit on again.
Sound is emitted from one speaker only.
• is the other speaker disconnected?
An erroneous display or a malfunction occurs.
-+ Reset the unit as stated beiow.
TUNER SECTION
There is constant, wave-like static.
• is the antenna connected properiy? (-+ page 3)
• is the signai weak?
-► Connect an outdoor antenna.
The reception contains noise interferences or the sound is
distorted.
• is Ihe system picking up externai noise or muitipath distortion?
-+ Change the orientation of the antenna.
-» Move the unit away from other eiectricai appiiances.
CASSETTE DECK SECTION
The tape does not run.
• Is the deck in pause mode? (-► page 11)
The sound is off-balance or not adequately high.
• Is the playback head dirty? (-> page 18)
Recording is not possible.
• Is the erasure prevention tab on the tape broken off? (-► page
12)
• Is the recording head dirty? (-► page 18)
Erasure Is not possible.
' Is the erasure head dirty? (-* page 18)
• Is a metal tape being used?
Higli frequency sound is not emitted.
• Is ,a tape recorded without Dolby NR played back with the Dolby
NFÎ system operating? (-► page 11)
• Is the recording/playback head dirty? (-► page 18)
CD PLAYER SECTION
The CD player does not play.
• Is the disc correctly inserted? (-► page 9)
• Is the disc dirty? (-► page 18)
• Is the lens affected by condensation?
-♦ Wait approximately one hour and try again.
Instructions about each part on the main unit or remote control
are indicated on the pages listed below.
(in alphabetic order)
Parts
BAND/MODE TUNER
CD
■ CLEAR
CLOCK
DEMO
◄◄ DOWN
EDIT/CHECK
EJECT
EQ
FUNCTION
MD
MODE
MULTI JOG
OPEN/CLOSE
PHONES
POWER
◄ ► PRESET/DIR
PRGM
RANDOM
• REC/REC MUTE
REPEAT
II
SET
SHIFT
SLEEP
TAPE/REV MODE
T-BASS
TIMER
TUNER/BAND
►► UP
VIDEO/AUX
VOLUME
0-9, +10
Pages
7
9
5, 8, 9, 10, 11, 13, 14, 15
5
5
5, 7, 8, 9, 10, 11, 14, 15, 16, 17
9, 14, 15
11
6
4, 14, 16
13, 18
5, 6, 11, 13
5, 6, 8, 9, 11, 13
9
5
5, 7, 16, 18
8, 9, 11, 13, 14, 15
10
10
13, 14, 15
10
5, 8, 9, 11, 13, 16
4, 5, 7, 9, 10, 14, 15, 16, 17
17
11, 13
6
16
7. 8
5, 7, 8, 9, 10, 11, 14, 15, 16, 17
13, 18
6
8, 9, 10, 14, 15
<
cr
LU
z
lU
C5
To reset
If an unusual condition occurs in the display window or the
cassette decks, reset the unit as follows.
1
F’ress the POWER button to turn off the power.
2 F’ress the POWER button to turn the power back on while
pressing the ■ CLEAR button. Everything stored in memory
after purchase is canceled.
If tire power cannot be turned off in step 1 because of a
malfunction, reset by disconnecting the AC cord and repeat step
2
.
ENGLISH
20