Connecting optional equipment, To cancel the sleep timer, Video/aux jacks & md jacks – Aiwa XR-M35 User Manual
Page 18: When connecting a turntable, Cd digital out (optical) jack, Line out jacks, Superwoofer
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OTHER C
SETTING THE SLEEP TIMER
CONNECTING OPTIONAL
EQUIPMENT
The unit can be turned off automatically at a specified time.
Use the remote control.
1 Press the SLEEP button while pressing the SHIFT
button.
2 Within 4 seconds, press the ◄◄ or ►► button
to specify the time until the power is turned off.
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.
Specified time
To check the time remaining untii the power is turned
off
Press the SLEEP button once while pressing the SHIFT button.
The remaining time is displayed for 4 seconds.
To cancel the sleep timer
Press the SLEEP button twice while pressing the SHIFT button
so that “SLEEP” on the display disappears. (The "SLEEP oFF"
indication appears.)
-CD DIGITAL OUT
(OPTICAL)
■MD
-VIDEO/AUX
■LINE OUT
-SUPER WOOFER
Refer to the operating instructions of the connected equipment
for details.
• The connecting cords are not supplied. Obtain the necessary
connecting cords.
• Consult your local Aiwa dealer for optional equipment.
VIDEO/AUX JACKS & MD JACKS
This unit can input analog sound signals through these jacks.
Use a cable with RCA phono plugs to connect audio equipment
(turntables, LD players, VCRs, TV, MD, etc.).
It is convenient to use MD jacks when connecting an MD recorder.
Connect the red plug to the R jack, and the white plug to the L
jack.
When connecting a turntable
Use an Aiwa turntable equipped with a built-in equalizer amplifier.
CD DIGITAL OUT (OPTICAL) JACK
This unit can output CD digital sound signals through this jack.
Use an optical cable to connect digital audio equipment (digital
amplifier, DAT deck, MD recorder, etc.).
Remove the dust cap
(D
from the CD DIGITAL OUT (OPTICAL)
jack. Then, connect an optical cable plug to the CD DIGITAL
OUT (OPTICAL) jack.
When the CD DIGITAL OUT (OPTICAL) jack is not being
used
Attach the supplied dust cap.
LINE OUT JACKS
This unit can output analog sound signals for all functions through
these jacks.
Use a cable with RCA phono plugs to connect audio equipment.
NOTE
Do not connect equipment to the LINE OUT jacks and VIDEO/
AUX jacks simultaneously.
Otherwise, noise is generated and malfunctions may occur.
SUPERWOOFER
Connect an optional powered sub woofer with a built-in-amplifier
to the jack.
1
7
ENGLISH