Aiwa XR-M35 - Manual (Page 15)

Al EDIT RECORDING
4
The Al edit function enables CD recording without worrying about
tape^ length and track length. When a CD is inserted, the unit
automatically calculates track lengths. If necessary, the order
of tracks is rearranged so that no track is cut short.
(Al: Artificial Intelligence)
Press the numbered buttons to designate the
tape length.
10 to 99 minutes can be specified.
Example: When using a 60-minute tape, press the
6 and 0
buttons.
In a few seconds, the microcomputer determines the tracks
to be recorded on each side of the tape.
• The and ►► buttons and the MULTI JOG dial are
also available to designate the tape length.
Tape length
O
z
o
QC
O
O
UJ
cc
iilüii
Tape side A \/ Remaining time
(front side) of side A
Number of
programmed tracks
Selected tracks
for side A
Al edit recording will not start from a point halfway into the tape.
The tape must be recorded from the beginning of either side.
Use the remote control from steps 3 to 5.
1 Insert the tape into the deck, and turn Dolby NR
on or off by using the MODE button and the MULTI
JOG dial. ( see “BASIC RECORDING step 3”)
hsert the tape with the side to be recorded on first facing ouf
f'om the unit.
2 F’ress the CD button on the main unit so that "CD"
is displayed, and load the disc.
^'ou can press the FUNCTION button on the remote control
repeatedly to display "CD".
3 F’ress the EDIT/CHECK button once whiie
pressing the SHIFT button.
“EDIT” lights up and “Al” flashes on the display.
Al
EDIT
o T i ..................
'i'i ? Í .1. i...
\ \ / /
ti i ; /11
/ ; ; /,
llil
5 First press the • button and then press the ►
button within 2 seconds to start recording.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and recording
starts. When recording on the front (side A) ends, recording
on the back (side B) starts.
■
To stop recording
Press the ■ button. Recording and CD play stop simultaneously.
To clear the edit program
Press the ■ button twice so that “EDIT” disappears on the
display.
To check the order of the programmed track numbers
Before recording, press the EDIT/CHECK button while pressing
the SHIFT button to select side A or B, and press the ►► button
repeatedly.
Program
number
Track number Programmed
track numbers
Time on cassette tapes and editing time
The actual cassette recording time is usually a little longer than
the specified recording time printed on the label. This unit can
program tracks to use the extra time.
' Recording is inhibited if the erasure prevention tab on either
side of the tape is broken off.
' The Al edit function cannot be used with discs containing 31
tracks or more.
ENGLISH
1 4