Listening to external sources, To c hange a source name in the display, Care and maintenance – Aiwa XR-M35 User Manual

Page 19: To clean the cabinet, To clean the heads and tape paths, To demagnetize the heads, Care of discs, Care of tapes

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

LISTENING TO EXTERNAL

SOURCES

To play equipment connected to the VIDEO/AUX jacks or the

MD acks, proceed as follows.

1 Press the VIDEO/AUX button when playing

equipment connected to VIDEO/AUX jacks, or
press the MD button when playing equipment
connected to MD jacks.

‘hflDEO” or “MD” appears on the display.

2 Play the connected equipment.

To c hange a source name in the display

When the VIDEO/AUX button is pressed, “VIDEO” is displayed

initia lly. It can be changed to “AUX” or “TV”.

With the power on, press the POWER button while pressing the

VIDEO/AUX button.

Repeat the procedure to select one of the names.

CARE AND MAINTENANCE

Occasional care and maintenance of the unit and the softwan-

are needed to optimize the performance of your unit.

To clean the cabinet

Use a soft and dry cloth.
If the surfaces are extremely dirty, use a soft cloth light!',

moistened with mild detergent solution. Do not use strong

solvents, such as alcohol, benzine or thinner as these could
damage the finish of the unit.

To clean the heads and tape paths

After every 10 hours of use, clean the heads and tape paths

with a head cleaning cassette or cotton swab moistened with

cleaning fluid or denatured alcohol. (These cleaning kits are
commercially available.)

When cleaning with a cotton swab, wipe the recording/playback

head, erasure head, capstans, and pinchrollers.

O-i

tu <

(£

:z Lu

o lij

After cleaning the heads and tape paths with a liquid head
cleaning cassette or a moistened swab, wait until the cleaned

parts are completely dry before inserting the tapes.

To demagnetize the heads

The heads may become magnetized after long-term use. This

may narrow the output range of recorded tapes and increase

noise. After 20 to 30 hours use, demagnetize the heads with

any commercially available demagnetizer.

Care of discs

• When a disc becomes dirty, wipe the disc from the center out

with a cleaning cloth.

• After playing a disc, store the disc in its case. Do not leave the

disc in places that are hot or humid.

Care of tapes

• Store tapes in their cases after use.
• Do not leave tapes near magnets, motors, television sets, or

any source of magnetism. This will downgrade the sound
quality and cause noise.

• Do not expose tapes to direct sunlight, or leave them in a car

parked in direct sunlight.

ENGLISH